Ce-niehoff-co A9-462 Energize Interrupt Switch Installation Bedienungsanleitung PDF herunterladen

II0032BPage 1 of 1

A9-462 Energize Interrupt Switch

For Use On

Externally-Energized CEN Alternators

Installation Instructions

C. E. Niehoff & C

BRUSHLESS ALTERNATOR

1. Turn off engine.

2. Disconnect battery switch.

Disconnect battery switch to

reduce personal injury or

equipment damage.

3. Remove B+ hardware at alternator.

Figure 1 - Stacking Order at B+ Terminal

C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633

This symbol is used to indicate the

presence of hazards that can cause

minor personal injury or equipment

damage.

CAUTION

4. Using emery cloth or equivalent, clean B+ hard-

ware contact surfaces. Spread light coating of

water resistant, dielectric grease on terminal

and lugs.

5. Install A9-462 Energize Interrupt Switch in

stacking order shown in Figure 1.

Failure to follow stacking order

will result in substantial

equipment damage.

More than two cable lugs on

B+ output terminal are not

recommended. To properly

engage brass terminal, B+ bolt

threads must be exposed a

min. 1/2" and max. 3/4" after

stacking order. Replace with

stainless steel bolt of suitable

length if necessary

6. Start engine. Check for alternator output.

B+ cable



A9-462 energize interrupt switch.

Cable lug only supports switch;

it does not connect

red or white wire to B+.



Copper washer



1/2-13 B+ bolt –

torque to 30 Nm/22 lb. ft.



This symbol is used to indicate the

presence of hazards that will cause

severe personal injury, death or

equipment damage.

DANGER

Lockwasher



Using ring terminal and plastic sleeve

provided, connect red lead

to E terminal on regulator.

Torque to 3.4 Nm/30 lb. in.



Connect white 35" lead,

using a soldered splice or similar,

to vehicle energize circuit



CAUTION

Cable lug from additional equipment;

see "caution" above



CAUTION

C. E. Niehoff & C 1

Inhaltsverzeichnis

Seite 1 - C. E. Niehoff & C

II0032BPage 1 of 1A9-462 Energize Interrupt SwitchFor Use OnExternally-Energized CEN AlternatorsInstallation InstructionsC. E. Niehoff & Co.BRUSHL

Kommentare zu diesen Handbüchern

Keine Kommentare

Ce-niehoff-co A9-462 Energize Interrupt Switch Installation Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Ce-niehoff-co A9-462 Energize Interrupt Switch Installation herunter. C.E. Niehoff & Co. A9-462 Energize Interrupt Switch Installation User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Ce-niehoff-co A9-462 Energize Interrupt Switch Installation